Step 1
Procedure, Cut and Install the Stringers

Eliminate the blocking for the original pipes.

Step the distance in between the studs so that you will certainly have a tight fit for your supports.

After the stringers have actually been cut, pre-drill them so they will be simpler to set up.

Set them in place in between the studs. Make certain they line up with the holes you pre-drilled for them through the tile. Protect them to the wall studs with wood screws. These 2 stringers are exactly what your lag bolts will attach to when you are ready to mount the shower system to the wall.

Step 2
Water resistant the Plumbing Behind the Shower

Position some duct tape around the supply lines in the back of the shower wall.

Inside the shower, fill the areas around the pipelines with silicone. The duct tape keeps you from filling the entire wall. The silicone will certainly seal up the holes and block any water that might run in between the shower system and the wall.

How to Install a Multi-Head Shower: Securing Shower System

How to Install a Multi-Head Shower: Securing Shower System

Step 3
Drill and Seal Holes for Lag Bolts

With the wall studs now reinforced to deal with the weight of the shower, and the holes for the brand-new water lines sealed up, you prepare to install the brand-new shower system and hook the water back up.

You need to pre-drill the holes in the stringers so your lag bolts will certainly enter.

Fill the holes with silicone so the extra will certainly seal up around the bolts once they are screwed into place.

Step 4

Attach the Unit to the Wall

Raise the shower unit over the supply lines and line up the holes for the bolts. Shim it once again to raise it the required distance off the basin floor.

Connect the system to the wall using a 1/2″ socket wrench to secure the bolts into the stringers. Then, get rid of the shim from beneath.

Step 5
Bleed the Lines at the Shower

Use “thread sealant” at the supply lines to prevent any leaks.

Install the water hoses inside the system to the brand-new lines.

Turn the water main on and bleed the lines at the shower.

Napkins work well to examine the fittings for any possible leakages. Inspect the fittings in the shower and in the wall where you ran the brand-new supply lines.

Step 6

Put Together the Shower Unit

Attach the hose for the spray deal with, and after that place the cover back on the shower base.

Replace the cylinder over the water valve of the unit, and screw the leading plate to the valve.

Set up a rubber gasket on the outside of the valve cover and install a small plastic pin in the face of the cover plate.

Set up the surface trim plate to the cover plate. The finish trim piece will snap onto the cover plate.

Install the covers for the faucet controls.

Loosen the top of the showerhead, and then screw the surface trim on.

Link all the nozzles and sprays on the face of the device.

No Comments

Be the first to start a conversation

Leave a Reply

  • (will not be published)